I need a simple rifle rack...
06-29-2007, 10:32 AM
#1
Thread Starter
Join Date: Mar 2007
Location: Kansas City
Posts: 20
I need a simple rifle rack...
I have a Stackon gun safe,that I bought from a friend a couple years ago,but it does not have the rack to seperate the guns.I am trying to find either the original plastic racks or plans for a simple,easy to build wood rack. I have not been able to find any plans,does anyone know where to find any? I have 7 guns,would like to have a rack to hold 8.
06-29-2007, 02:28 PM
#3
Nontypical Buck
Join Date: Feb 2003
Location: MB.
Posts: 2,984
RE: I need a simple rifle rack...
Why don’t you go to a sporting good store that has gun safes on display and trace the pattern on a piece of cardboard then it’s just a matter of modifying the pattern for your safe...
06-29-2007, 02:37 PM
#4
Boone & Crockett
Join Date: Feb 2003
Posts: 10,679
RE: I need a simple rifle rack...
A strip of 1/2" plywood that is 3 inches wide by how ever many inches long your safe is.
Draw a center line down the length of the plywood. Get a 2" hole saw and drillholes every 2.25 - 2.5 inchesdown this center line.
Saw that board in half right down the center line and you will get two racks.
Glue some felt in the inside of the holes.
Should cost you only a few dollars.
Draw a center line down the length of the plywood. Get a 2" hole saw and drillholes every 2.25 - 2.5 inchesdown this center line.
Saw that board in half right down the center line and you will get two racks.
Glue some felt in the inside of the holes.
Should cost you only a few dollars.
07-06-2007, 04:00 PM
#6
Nontypical Buck
Join Date: Feb 2005
Location: Maine
Posts: 1,327
RE: I need a simple rifle rack...
ORIGINAL: bigbulls
A strip of 1/2" plywood that is 3 inches wide by how ever many inches long your safe is.
Draw a center line down the length of the plywood. Get a 2" hole saw and drillholes every 2.25 - 2.5 inchesdown this center line.
Saw that board in half right down the center line and you will get two racks.
Glue some felt in the inside of the holes.
Should cost you only a few dollars.
A strip of 1/2" plywood that is 3 inches wide by how ever many inches long your safe is.
Draw a center line down the length of the plywood. Get a 2" hole saw and drillholes every 2.25 - 2.5 inchesdown this center line.
Saw that board in half right down the center line and you will get two racks.
Glue some felt in the inside of the holes.
Should cost you only a few dollars.
Thread
Thread Starter
Forum
Replies
Last Post
TexasOaks
Whitetail Deer Hunting
4
06-25-2007 05:20 PM
