Rem 7600 - 308 to 7mm-08
 

Can you switch out a 7600 .308 barrel with a 7mm-08 barrel without much difficulty.......assuming you can find a 7mm-08 barrel? Any ideas where to get a 7mm-08 barrel that will fit a 7600?

I've found a couple of 7600's in 7mm-08 at GunBroaker, etc, but they are VERY Expensive in the $800-$900+ range.

I figure that if it is doable, you should be able to pick up a doner 7600 .308 and then put a decent 7mm-08 barrel on it.

Thanks
firstshot
------------------------------------------------
Make your first shot count.

RE: Rem 7600 - 308 to 7mm-08
 

The 7600 can be rebarreled to 7mm-08 Most good gunsmiths should be able to do the job.

RE: Rem 7600 - 308 to 7mm-08
 

Never Mind!!!
I just found out that Grices is doing another 7600 special run in 7mm-08 with black laminate stock. Going to call them and put my deposit down tomorrow!

Link to Grices Special Runs

Thanks Anyway!

firstshot
---------------------------
Make your first shot count!

RE: Rem 7600 - 308 to 7mm-08
 

LOL Grice's to the rescue!!

RE: Rem 7600 - 308 to 7mm-08
 

If only I had seen your post sooner. I knew about the Grices thing. I ordered one of the 7600's in 7mm-08. Hopefully it will the last rifle i buy in a wile.