HELP! Browning A-bot Recoil pad!
I have a 1993 Browning a-bolt Medallion in .270.I have been wanting to replace the recoil pad to reduce the recoil.I have the new pad so I went to install it.I took out the two screws but the recoil pad will not move at all asit is if I still have serews in it.Can someone tell me what is holding me up.I also have a Browing a-bolt that is only 2 years old and I took the two screws off of the and the pad came right off.What an I doing worng on my 1993?
|
RE: HELP! Browning A-bot Recoil pad!
It must be clued a little bit. I changed the pad on My Browning A-Bolt stalker. It has a synthetic stock though. When I removed the screws it came right off. Is yours a wood stock?
|
RE: HELP! Browning A-bot Recoil pad!
Yes it is a wood stock.
|
RE: HELP! Browning A-bot Recoil pad!
I bet the glued it enough to hold it on while they put the screws in. It shouldn't be stuck to tight thiugh. I have not run into any that were glued on.
|
All times are GMT -8. The time now is 04:08 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.