some help with a kel-tec pistol please...
 

i am trying to install the belt clip on my kel-tec and need to remove the frame pins and i have no idea how to get them out.

if anyone is familiar with these pistols, any advice?

RE: some help with a kel-tec pistol please...
 

Not sure how to install a belt clip. I use a ITP holster for mine. No way am I carrying a pistol with no safety without the trigger being covered.

RE: some help with a kel-tec pistol please...
 

I put one of these on my Kel Tec and didn't have to remove the pins. You just degrease the side of the dust cover and glue it on, as I recall.

RE: some help with a kel-tec pistol please...
 

GLUE IT ON?

The two pins press out, one at a time replacing the removed pin with one of the pins provided that are internally tapped. Then you use the two little screws to attach the spring steel clip with a little serviceable lock-tite.

I love mine. It allows a nice in the waist band carry and the trigger is covered with your pants.

I will pull the booklet out in the shop and double check, but I remember replacing the pins with the internally thread ones.

RE: some help with a kel-tec pistol please...
 

Alright - that was easy. It was in the first place I looked.

INSTALLATION INSTRUCTIONS FOR THE P11 PISTOL BELT CLIP

Parts List
1- BELT CLIP #11-380
2-FRAME PINS #P11-203
4-BUTTON HEADS SCREWS 6-32 X 1/4" LONG
1-5/64 ALLEN WRENCH

STEP 1
remove 2 existing prame pins (the 2 #203 pins above the trigger, not the rear 1), install 2 new #203 frame pins (which are internally threaded) provided with clip.

STEP 2
Install 2 of the 4 screws into the left side of pistol's pins. Do not overtighten these screws.

STEP 3
Fasten belt clip in place with 2 remaining screws. Refer to picture on other side. Do not overtighten these screws.

CAUTION: Do not install belt clip on left side of pistol. This will interfere with the safe operation of the pistol.

RE: some help with a kel-tec pistol please...
 

be sure and loc-tite them in place, because they will loosen under recoil.

RE: some help with a kel-tec pistol please...
 

My Kel Tec is a P-32. They give you a little strip of rubber, sealed in plastic,with some serious glue on each side. And a little pouch of some degreasing solvent. You de-grease the dust cover and put the little rubber strip between the dust cover and the clip. Very secure.