200 hp Johnson
I just purchased a 1990 GT 200 hp Johnson outboard and was wanting to change the water pump impellor. Anybody know how big a job that is, if there are any tricks to it. Also, how much oil and what kind goes in the bottom end. Thanks
|
been several years since i've done an OMC, but best i can remember the shifter linkage is the only thing that can be a little tricky, as for lower unit lube, i think it calls for 85 or 90 to about 110 wt. ....
a great source for boat, motor, and electronics questions is www.bassboatcentral.com there is a johnson/evinrude motor forum there they be able to "walk you thru" every bit of it along with 110 other forums, good source for all you fishing and boating questions:s4: good luck, i have run merc's for the past 17-20 years and there a breeze to work on the LU, and i'm sure yours won't be bad either, just a matter of knowing the "little tricks" that make it slide together:s4: |
Thanks M.T. I'll check out that website.
|
All times are GMT -8. The time now is 10:50 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.