muzzy 3 blade?
 

Any one had any problems using muzzy 100 3 blades? I bought a new pack of 6 and has my bow sighted in good with the old ones from last year, and there still on. the new ones are all hitting about 4 inches high. any ideas? or should i just readjust to the new ones?

I had problems with them before but then i switched to longer fletching and they fly like field points.

I shoot them and I haven't had any problems with mine shooting high. I have a couple different packs of them and they all shoot the same.

Both sets of yours are the same grain correct? I am assuming they are but it never hurts to ask.

I will agree with this. I shot a few of mine with blazer vanes and my groups weren't all that great but when I went to the longer vanes my groups tightened up.

I shoot Blazers and MX-4 Muzzy's without any problems. I did have to tune and tweak a little with my rest. But, that is a normal thing in most cases.

yes, the old and new are both 100 gr. i just switched to blazer vanes from 4 inch fletchings. th old ones and the new ones group good. its just the new ones are grouping 4 inches higher than the old ones.

do you have a digital scale that you can weight them? Maybe there packaged wrong. I have one and always weigh mine to make sure everything stays the same.

It sounds like your blazer vanes may be hitting your rest. I shoot Muzzy myself with blazer vanes. I use a drop away but if you use a whisker biscuit...you may need to look at that. I also had to adjust sight when I took my bow out for the year. It was shooting right from last year. Hope this helps.

are you sure one pack aren't mx3's and one pack standard 3 blade?

That's what I shoot. No problems with mine. I would just adjust your site to the new grouping.