nock bushings for carbon express
 

anyone know what size bushings will fit the carbon express terminator lite select shafts? Getting tired of getting nocks busted off at 3d tournaments.

RE: nock bushings for carbon express
 

I can tell you that the 250 are a differnt size than the 350's......But the terms are rated 4560 and 6075.......I don't know which ones you are shooting, but try the collars for a 250 if you are using the 4560's, and the 350's for the 6075's.....

CX also makes their version of the pin nock....Those would would be better for what you're wanting.

RE: nock bushings for carbon express
 

I believe a 3-60 uni bushing will fit a 250. They did mine anyway.



Those bulldog collars, were a bit overrated in my opinion, they definately aren't going to protect your nocks, nothing is going to do that. The collars just seem to protect the "glance offs"

RE: nock bushings for carbon express
 

The collar was never intended to protect the nock, just the end of the shaft, which it does extremely well.

I don't know why I didn't think of that, but you're right...The 3-60 bushing will fit, and it will probably fit the 350 as well. I bet that's what you'll need, unless you decide to go w/ pin nocks.

RE: nock bushings for carbon express
 

I don't know about the 350's but the 3-60's worked pretty well in my 250's.

RE: nock bushings for carbon express
 

I'm shooting the 60/75's I'm not worried about the nock, its cracking the end of the arrow thats getting on my nerves, and my wallet!

RE: nock bushings for carbon express
 

That is exactly what the collars are intended.....Give the 350's a try, I think they will work.