![]() |
Arrow rest?????? HELP!!!!!
I need ya'lls help i have a whikser (CRAP) biscuit
I had a buck come in yesterday i draw my hoyt back when he was behind two huge pine trees all i can see of him is his ears as soon as my Beman slides threw my whikser (CRAP) biscuit he pins he ears and runs away he was already nervous i know he heard my arrow coming threw So what i am asking is what kind of rest should i buy asap????? |
RE: Arrow rest?????? HELP!!!!!
I have never used a biscut, but my older brother does. He waxes his arrows. Not sure how much it helps, but that is what he does.
As far as rests, any will work. Most, you can put mole skin on then to make them quiet. I have a couple of Muzzy zero effects that are whisper quiet. I have mole skin on the turkey spur and my riser. |
RE: Arrow rest?????? HELP!!!!!
I use a whisker biscuit and have never had that problem. I don't know what is going on but that sounds weird. I love my whisker though.
|
[Deleted]
[Deleted by Admins]
|
RE: Arrow rest?????? HELP!!!!!
i use the bowtech hostage. It has contact with the arrow in three spots and your fletchings never touch it. better for your fletchings and very quiet.
|
RE: Arrow rest?????? HELP!!!!!
Get rid of the biscut, i used to shoot one and always had noise on the draw. Shoot a Trophy Ridge fall away now, more accurate and quiet too
|
RE: Arrow rest?????? HELP!!!!!
I use a biscuit, and I love it. You may need a new one, those bristles get frayed like an old toothbrush and can make some noise, but I can't believe it was enough to spook a deer. Are you sure it wasn't something else. Make sure you have the respective rest as well, aluminum for aluminum and carbon for carbon.
|
RE: Arrow rest?????? HELP!!!!!
Drop Away Rest!!!!!!!!!!!!!!!!!!!!!
|
RE: Arrow rest?????? HELP!!!!!
I use the QAD drop away rest. Full containment with the accuracy of a target rest. There is no way I would use a whisker biscuit, I don't even want the bristles touching my fletching.
|
RE: Arrow rest?????? HELP!!!!!
i use a quick tune 1000...And i love it
|
RE: Arrow rest?????? HELP!!!!!
ORIGINAL: burniegoeasily ...He waxes his arrows... I also have been busted by WB noise when drawing. I think that one cause iswhen scent elimination spray gets on my arrow shaft, caused some friction/noise when drawing. I have also have seen recommendation to put moleskin on lower section of WB bristle where thearrow rests. I tried it, but the moleskin lasted about 3 shots before pulling off. All I know is I also need to find a way to silence my arrow when drawing, as Idread trying to draw during those dead-calm dayswhere any noiseis enough to get busted. By the way, I just found this on the http://www.trophyridge.com/tips-tricks/page: My arrows make noise during the draw, how can I quiet them down? There are many types of arrows on the market. Some are more quiet than others. Here is what we know about making an arrow draw quietly through the rest: [ul][*]Carbon arrows with a smooth finish are the quietest. Trophy Ridge arrows, with their Silent Slide⢠Shaft Coating, are the quietest arrows through the Whisker Biscuit. Other carbon arrows will be noisy at first, but after shooting them many times, they become less noisy. You will find that even the noisiest arrows will become very quiet after several hundred shots.[*]Shafts can be smoothed slightly by rubbing with very fine steel wool.[*]Large diameter aluminum arrows (24XX-25XX) are very noisy. They are very sensitive to dust and abrasion.[*]Camouflaged aluminum arrows are noisier than solid color arrows.[*]If the biscuit fits tightly around the arrow, the noise will be substantially increased. A loose fit that allows light to be seen over the arrow when it is mounted on the bow will give the quietest and most forgiving setup. You can spread the biscuit open slightly to increase the opening.[*]Applying silicon to the arrow shaft sometimes reduces the noise.[*]Keep the biscuit clean. Wipe the arrows prior to use. Avoid contaminating the biscuit with waxes, dirt, dust, target material, etc. Avoid using dry powder type waterproofing as it is abrasive and will increase arrow drawing noise.[*]Check that the biscuit is square to the arrow. Sometimes a noisy setup can be cured by pushing the top of the biscuit towards the bow string a little with your thumb. Paper tuning the bow will help optimize the rest position and can decrease draw noise.[*]Make sure the arrow is not pressing down on the rest with excessive force. If you are using nock sets above and below the arrow, they may be too close at full draw. This can cause more pressure on the bristles and increase draw noise. [/ul]If you are hunting on a cool damp morning, it is sometimes helpful to wipe the arrow and cable rod so it is free from condensation when you arrive at your stand. [/align][/align] -Rick C. |
RE: Arrow rest?????? HELP!!!!!
i have the right one!!!!!!!!!! the deer was only 15yrds no wind at all!!!!!!
Thanks rickc.!!! |
RE: Arrow rest?????? HELP!!!!!
Never shot a wb before. Get a fall away rest and use some moleskin. I've shot the Shakey Hunter the last two seasons, but switched to theRipcord this year. I prefer it over the sh or a biscuit.
|
RE: Arrow rest?????? HELP!!!!!
the vapor trail limbdriver is "bar none" the best rest I have ever used. Put a little mole skin on the prongs and it doesn't make a peep. The best thing about the rest is it's idiot proof.
|
RE: Arrow rest?????? HELP!!!!!
Drop away. I picked up 7fps by switching from a two prong to a drop away.
Tom |
RE: Arrow rest?????? HELP!!!!!
I just put on the new hostage. Good rest less contact than you biscuit.
|
RE: Arrow rest?????? HELP!!!!!
Throphy ridge drop zone. Definately recomend a drop away rest over any other rest. It just makes more sense to use zero resistance compared to any
|
RE: Arrow rest?????? HELP!!!!!
If you do not have the WB set right it will have a shimmy sound on draw,when set up right they are quite.I have been useing the WB from the time it was brought out also you only lose about 1-2.5 fps useing a WB,if your loseing more you have issues.
FIND a REST YOULIKE,Not what someone else says is the best....;) |
RE: Arrow rest?????? HELP!!!!!
I have been using a WB for several years, mine has never made a peep. Hope you figure it out, it really can be a great rest.
|
RE: Arrow rest?????? HELP!!!!!
switch to a drop away like the QAD ultra rest . full containment but no contact on release
|
| All times are GMT -8. The time now is 10:18 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.