Can't make them Blazers stick!
 

I have been switching over to the 2" blazers on my existing arrows. However I've had an awful time making them stay on the arrow! They fly off all the time. I love how well they work, but I'm not sure how to make them stay on the arrow. Anyone have any thoughts on arrow prep or any tips that work for you?

RE: Can't make them Blazers stick!
 

If you are cleaning the base of the vane, DON'T. Clean the arrow w/ alcohol and use some good glue. What glue are you using? I use Pine Ridge, but any of the cyanocrylate's work just fine.

RE: Can't make them Blazers stick!
 

Don't clean the vane, and to prep the arrow, just use water and let it air dry. If you still have problems, you could consider using wraps. They stick to wraps pretty good.

RE: Can't make them Blazers stick!
 

I use wraps and don't clean the vane. Never had a problem.

RE: Can't make them Blazers stick!
 

use the wraps

RE: Can't make them Blazers stick!
 

I'm using bohning quantum xt glue and I'm gluing these things onto carbon arrows. Perhaps I should consider using the wraps but aren't they a good bit more expensive?

RE: Can't make them Blazers stick!
 

TerryM had the same problem ,he contactedthem and they sent him a few new pack's of vane's to make it right .Try contacting them, I'm sure they'll make it right for you.

nubo

RE: Can't make them Blazers stick!
 

If your vanes are @ a year old give them a shout they had a bad batch hit the market you may have some of those, I know I did. They did right by me and the new ones stick no problem both with and without wraps.

RE: Can't make them Blazers stick!
 

Use denatured alcahol onthe vanes and shafts , The Bohning instant gel is the best I've found for glue. Also it helps to put a smal dab on the tip of the vane where it meets the shaft after fletching.
I started using the mini blazers this week, so far I am impressed both fp's & bh's fly well. I may switc the rest of my arrows over after a bit more testing.
good luck

RE: Can't make them Blazers stick!
 

I have only fletched 2 arrows with blazers but they are still intact. Someone on here said to take sandpaper to the base of the vane to rough it up. I did this just for giggles though.:D Don't know if it helped b/c they should stick to begin with. Worth a try.