Clearance with a MZE
 

I know that there has been a post about this recently, but I sure cannot find it - so here goes:

I have a MZE on my 2006 Hoyt PowerTec. I purchased the Hoyt specific brand of MZE and I installed just like they said. I can get the arrow to fly straight when I do I always clip one of the veins on the side of the rest. I have tried everything: twisting the nocks, moving the rest left and right and more up and down on the draw - but for me to get the arrow to fly straight that rest has to be in a certain position and if it is it is hitting my vein on the left side (cock feather up) towards the rest and away from the bow every single time (I put lipstick on th vein and it was rubbed off my the rest.

Now it is only making a small amount of contact so maybe I should not worry about it (I tend to be neurotic about these kinds of things). But I am about to switch to blazers with this years arrows and I am afraid the problem will only be worse - a little help would be GREAT!

RE: Clearance with a MZE
 

Did you try shooting cock vane down? This would put your hen vane higher into the launcher "basket" and give it more clearance.[/align]