Looking at breech plugs!!
#93
Nontypical Buck
Join Date: Aug 2008
Location: Rapid City, South Dakota
Posts: 3,732
slight rim dings
Yes, those plugs may very well leak, because they won't be able to make a good seal with the barrel. Those tiny tiny dings on the rim, will allow blow by. Here is my opinion from a few days ago....
#95
Nontypical Buck
Thread Starter
Join Date: Mar 2009
Location: Saxonburg Pa
Posts: 3,925
I don't understand why CVA uses cheap soft material in there plugs??? Ecspecialy in Accura MR. This is a $400.00 gun, not a $200.00 wolf or something. Knight also frustrated me when they went with a cheaper steel instead of 17/4 stainless. 416 stainless is cheap to.
#98
I never trade this but can you sand just the flat tip of the ring just to take the dings out as long as there not to deep and steel work and seal. and you may want to do it before you mate to bore.
Last edited by a1smokepole; 01-14-2016 at 07:27 PM.
#99
Nontypical Buck
Join Date: Aug 2008
Location: Rapid City, South Dakota
Posts: 3,732
#100
Nontypical Buck
Thread Starter
Join Date: Mar 2009
Location: Saxonburg Pa
Posts: 3,925
I was trying to find out the difference between the CVA BH209 version versus the Western Powders version. All the the info I got here was they were the same. But I find most people don't pay attention to detail I should of known better.