HuntingNet.com Forums

HuntingNet.com Forums (https://www.huntingnet.com/forum/)
-   Black Powder (https://www.huntingnet.com/forum/black-powder-23/)
-   -   paper patched lee 501-440: white muzzleloader, cva wolf (https://www.huntingnet.com/forum/black-powder/378195-paper-patched-lee-501-440-white-muzzleloader-cva-wolf.html)

corey012778 01-21-2013 02:25 PM

paper patched lee 501-440: white muzzleloader, cva wolf
 
finally I got to the range. took the paper patch bullets idohoron made for me.
70grs pyrodex p
wolf: fed. fusion primers
white lighting (the gun not the drink): remington #11 (had just enough for this test)
scopes: wolf: konus 3-9 x40, white: tc 3-9 x40

50yrds white lighting, slipped right down the barrel the rifling catching the paper. shows promise

until I keyholed one


50yrds cva wolf. this gun seems to like this set up at this distance.
sight in.


forgot to load the bullet on the first shoot. shot one blank.


100yrds with the wolf, the wind picked up to 15 to 20mph, started moving my target around. but still, that is only a 6 inch target.



the recoil was not that bad at all.

idahoron 01-21-2013 05:34 PM

Did you use an over powder wad with these bullets? The load most of the rifles like I have shot is 80 gr of pyrodex P with an over powder wad. That key hole is odd. I have not seen that happen. I have never known anyone to shoot those bullets out of those guns but I would have thought they should have grouped better.

corey012778 01-21-2013 06:15 PM

it was just a fit and feel test, but next time out, I am going to use wads. had them. the keyhole throw me. may be upping the charge will bring the groups together.

idahoron 01-21-2013 08:27 PM

It might. The blow by on the White might have been the reason for the tumble. I also wonder a little about the hardness of the lead. I don't think that would be a problem but I got to wonder. Wasn't the bore on the white kind of questionable? Ron

corey012778 01-22-2013 11:19 AM

it was when I first got it. since then I cleaned it up really well. the bore is not pitted. just looked worst then it really was. shoots powerbelts just fine. shot 3 just to see if there was anything wrong, those are about the same diameter as those boolits.


I may wrap some with the paper I got, I have about 20 or 30casted up, I know that lead is much softer.

idahoron 01-22-2013 04:26 PM

I should have left some unsized to get a tighter fit. I wasn't sure how they would fit. Try an over powder wad. Ron

corey012778 01-22-2013 05:30 PM

I will try a wad next time out. think a wad or powder work will help bring it together more


All times are GMT -8. The time now is 01:23 PM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.