Coming Closer To Figuring Out My BC Triumph
 

Well I went back out to the range today. Started out again with 85 grains and still could not hold a group together. I thought for the heck of it I would try 90 grains. Boy what a difference 5 grains made. After alittle adjustment with the scope I had two shots dead center and touching. Then two shots two inches right and one inch low. The other three shots were almost center but low. I think the reason I lost dead center was lack of focus. There was a elder gentleman with a 17 HMR and was having a heck of a time sighting it in. Well in shooting my last shots I was helping him and just wasn't focused. Got him all sighted in though, so that is a plus for today. But I'm slowly figuring this gun out. Also I checked my sabots to see if they were torn up or any damage if I had lands in my barrel. They looked flawless, could almost use them again. I should be able to have this figured out before hunting season, just 11 days till black bear season. :barmy:

Was that 90 grains by volume or weight? If it was volume, I would increase the powder charge to over 100 grains to see what happens.

50calty

This sentence worries me a bit.... what sabot are you using? It really does not sound snug enough...

I understand with the low amount of powder you are using that the petals would not be peeled back but you should see the engraved lands marks on the sabot.

One other thing, I am thinking - the sabot is supposed to obturate to the bore with the combustion of the powder - it the sabot is to thin you would need to up the powder amount to get that done to insure a positive sabot/bore seal.

Kinda what you are saying right here.. more powder created a better seal... I have a regular Triumph and I am shooting 110 grains T7 with 250 to 300 grain bullets and it shoots lights out... Also I am shooting a MMP HPH-24 sabot other find the short black Harvester works best for them, they both fit very snug.

Not trying to get you off track just tossing out some ideas...