Pull and clean the trigger mechanism????
#1
Fork Horn
Thread Starter
Join Date: Feb 2008
Posts: 155
Pull and clean the trigger mechanism????
Do you recommend me pulling the trigger mech out of the encore (still the box) and spraying it as well? This is my first ML and I didn't know whether or not I should go there.
#2
RE: Pull and clean the trigger mechanism????
You can't just pull the trigger assemby on an Encore. You basically disassembly the trigger, sear, and hammer assembly; and other associated parts. If you are not familiar with these components and how they are reassembled, I would not recommend it. You can remove the trigger gaurd to gain access to the trigger assembly internals. You could then spray clean and oil the area without disassembly.
In my opinion a trigger job on an Encore is one of the best improvements you can make. I work mine till they break like glass.
In my opinion a trigger job on an Encore is one of the best improvements you can make. I work mine till they break like glass.
#3
Typical Buck
Join Date: May 2006
Location: Chippewa Falls WI
Posts: 914
RE: Pull and clean the trigger mechanism????
I just oiled mine lightly and shot it It take a quite a few shots to break in a trigger. I was fortunate that I have a 3 lb trigger from the factory. It breaks clean and is great to shoot.