HuntingNet.com Forums

HuntingNet.com Forums (https://www.huntingnet.com/forum/)
-   Black Powder (https://www.huntingnet.com/forum/black-powder-23/)
-   -   Lyman GPH fit and finish (https://www.huntingnet.com/forum/black-powder/180179-lyman-gph-fit-finish.html)

Texasimport 02-12-2007 08:26 AM

Lyman GPH fit and finish
 
Boy. . .looked at 3 different Lyman GPH this weekend and I must admit I must be expecting too much. . . .All three will require full tear down to finish sanding the stocks. One had a nice chunk missing on the but where it marries to the but plate. Another had issues with a clean fit around the trigger, and the third wasn't what I wanted either. . . .Looks like I need to keep looking until I get one made before lunch. The staffwould not allow me to swap stocks etc. [:@]

Is this the norm. . .is this all I should expect from a weapon in this price range? Never noticed this with stuff when buying cartridge guns, such as my Remington, Browning and Winchester Hunting rifles. Did have to get a new trigger for the Remington but that has been about it.

cayugad 02-12-2007 08:41 AM

RE: Lyman GPH fit and finish
 
I don't have a GPH but a Trade Rifle. I ordered mine sight unseen from an online store. My only complaint was the finish on the riflelacked a little to be disired. So I lightly sanded it a little rubbed in some boiled linseed oil and later waxed it and it is beautiful now. The single trigger on the rifle is exceptional and the hardware to stock fit is perfect. No complaints. Oh.. and the thimble rib screws fell out. Lyman sent me new ones and these new ones are lock tight installed.

MLKeith 02-12-2007 09:25 AM

RE: Lyman GPH fit and finish
 
My Trade Rifle is about the same as what Dave described. The stock finish is dull and would require some work if a nice appearance is desired. As far as fit I have no complaints, I have not shot the rifle a lot yet so I can not comment on overall performance but initially it is about what I expected for a production gun. The stock fit was a little tight and I was concerned that I might crack it attempting to install the barrel. I had to use a lot of caution.

frontier gander 02-12-2007 11:37 AM

RE: Lyman GPH fit and finish
 
Another complaint i see often is the finish on the barrel rubbing off easily. If i were you and really had my eyes set on one of these, i'd buy a kit and do it the right way. If not, Just take your time and shop around for something you're happy with.

lonewolf5348 02-12-2007 12:15 PM

RE: Lyman GPH fit and finish
 
I have read many post on the GPR seem there metal and wood fit are going down the tube.
I had one some time back in percussion shot excellent but the hammer was so far off had to do a little bending to hit right.The stock finish was ruff,wedge pins fell out and for me a little too long on the barrel for hunting all day walking,I like my t/c and don't hear them old wife tales 1 in 48 twist won't shoot mine are tack driver using heavy charges of 3F and round ball and patch


All times are GMT -8. The time now is 02:39 PM.


Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.