powder mesure
 

Dum question: how do you mesure loose powder?By filling the mesure to the mouth or filling it up to the mouth then tap on the side of the mesur and fill it to the mouth again?

RE: powder mesure
 

Preset yere measure to what ever grains by volume you want to try or use and fill to top. As you close measure any loose above will be leveled if you have a funnel type measure. Don't pack powder or tap![&:]

RE: powder mesure
 

The age old question of; to tap or not to tap... :D

If your measure has a cut funnel I suggest overfill it slightly, and then cut the charge level. I have weighed out charges to see how different they are, and it would surprise most as how close a loose pour cut charge is. If it has no cut funnel, I have taken a patch knife and struck off/dragged the measure level like your mother did with spices in the kitchen when baking.

If you are one of them that thinks by tapping you can get more powder into the measure, instead, try setting a slightly heavier charge on your measure, and pour a loose cut charge instead without tapping. If you must tap, then try to tap the same number of times in the same way each and every time.

Actually a grain or two will not make a huge difference in your accuracy. Some rifles I have, can shoot the same with as much as five grains difference. What you're doing is trying to develop a pattern of loading so that every time you load you do it the same as the time before. This conformity in loading will lead to better accuracy in the long run.

RE: powder mesure
 

hmmm ive always been a tapper lol...but thinking about it...and hearing cayugads results...by doing that i might as well move up 5 grains......thanx again cayugad...thats good info....

RE: powder mesure
 

No tamping/tapping needed or required.

RE: powder mesure
 

I think as stated consistency is the key. I slightly overfill, tap once, and once only, then cut. But the guys who say they don't tap have way more experience than me.....

To answer your original question, I think the kind of measure with a funnel that swivels out of the way is the best for me. That way, I fill it, cut if off at the top with the funnel, then use that to load my rifle or refill my powder containers.

RE: powder mesure
 

http://www.midwayusa.com/eproductpage.exe/showproduct?saleitemid=713372 sorry, but it do indeed make a difference.

RE: powder mesure
 

UC
That thing any good ?
Ken

RE: powder mesure
 

I have one of them also Ken and the thing is easy to use and very accurate. I have weighed a few loads but that just got to be too much work. It is a shame that there is not an AC adaptor for the thing. It runs off batteries, and you need to have it on a solid level surface when weighing out anything or I found it can get some strange readings.. I really like the scale for what little I use it..

RE: powder mesure
 

I actually like it better than my PACT as it seems less finicky and just as accurate. Dave is right about no wall-wart DC adaptor though. The good news is (as far as the batteries) that it takes a size 2032 coin cellwhich are available most everywhere for about a buckapiece or less (much less in bulk). That happens to be the same size battery as is on most computer motherboards so I have a bunch of them.