round cleaning patch size??
What size round cleaning patch is most efficient for .50 cal barrels?
|
RE: round cleaning patch size??
ORIGINAL: racks-n-beards What size round cleaning patch is most efficient for .50 cal barrels? 2-1/2sare tough to find in stores -- round ones even tougher. Isometimesbuy the square 2-1/2"s online. Otherwise, I'm finding square 3" or similar that are used for 12-16 gauge shotgun bores. I tried the 2" once. They are a tad too small to do a proper cleaning job for 50-cal rifles. They are better served for 45-cals. The most imprortant matter with patches is getting the all-cotton ones. I hate the poly-patches. They sometimes don't want to come back up after reaching the breech. I got about 250 of those left that I strictly use for wiping the ML exterior now. I think these below are my Best Buy right now for a throw-away patch. You get 300 that are 3" for $4.72. If you have a Meijer store near you, they sell these. http://www.midsouthshooterssupply.com/item.asp?sku=000601205S |
RE: round cleaning patch size??
2 1/4" seem to work. Those are the store bought size.
|
RE: round cleaning patch size??
ORIGINAL: racks-n-beards What size round cleaning patch is most efficient for .50 cal barrels? http://www.midwayusa.com/eproductpage.exe/showproduct?saleitemid=271437 |
RE: round cleaning patch size??
How many of you when you patch a bore use two patches? I use two, so that the jag and patch is a really nice tight fit. I get my patches back that way and I can even see rifling marks on them sometimes so I know I am getting into all the right places...
maybe my store bought Rusty Duck are 2 1/2inch. I am out of them and measured the jar and then figured they would not have ran them the full 2 1/2 inches into it but I could be wrong... Actually I use scrap patches. I get them at Wal Mart and they come in strange sizes. I cut a chunk what I need, make sure I get a tight fit and swab away.... |
RE: round cleaning patch size??
I tend to make my own cleaning patches using old flanel shirts and other suitable cotton material. I find they fit the bore tighter so I don't have to double patch like Cayugad described. My patches average about 2"x2" give or take a quarter inch or so usually smaller because the material is thicker.
|
All times are GMT -8. The time now is 01:37 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.