|
RE: NEW BARREL FOR ROUNDBALLS
ORIGINAL: lemoyne I have both 1-48 and 1-66 as a matter of fact I have a 1-38 too they all shoot 3 inch groups they do have to be clean as mentioned above and if you have any off center ramrod ware you have to cut a couple inchs off and rebutton the barrel.The big differance that twist causes is in the loads that they require to shoot good;each gun is an individualso their may be some exceptions but in mine the 1-38 takes 70 the 1-48 takes 110 and the 1-66 takes 120 of RS pryodex. Lee |
RE: NEW BARREL FOR ROUNDBALLS
ORIGINAL: cayugad ORIGINAL: keyshunter I have an old T/C Hawken flintlock (pre QLA),that I use for hunting. It has the standard T/C .50 cal barrel. It will pile round balls one on top of another at 25 yards, but at 50 yds. the groups open up to about 6 inches, andbeyond that really open up.Since I try never totake a shot over 50 yards, I have not worried about it. Could I expect better groups with a slower twist barrel? I think you should expect better then six inches at 50 yards. The first thing I would do is get some BOILING HOT SOAP AND WATER and clean that barrel of all gunk and crude that might be in it. Over all the years it could be the rifling is just filled with gunk. After that I would take some strong solvent and with a brass brush scrub that bore spotless. After swabbing any and all crud out of the barrel with solvent patches, then run a couple alcohol patches down it followed by three or four dry patches. Now immediately swab that bore with a quality gun oil that will soak into the pores of the metal in the bore. After you have the rifle nice and clean, swab the oil out of the barrel before you shoot next time with an alcohol patch. Then start all over working up a patch and roundball load. Good luck with the rifle. |
| All times are GMT -8. The time now is 05:56 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.