Another tip for the kwikee quiver.....

I have seen on many that the quiver itself does not always fit snugly into the quiver bracket which is mounted onto the bow. What I have done in the past is apply a little fletch-tite on the flat surface of the mounting bracket next to where the mounting screw holes are installed. I let the fletch tite dry and then add another layer or two. After about a day I then slide the quiver into the bracket to see if I have applied enough to get it to fit snugly. If not then I just repeat the steps above over until it does.

Now, in case my directions were a little fuzzy, I am not advocating glueing in your quiver into your quiver mount but rather using the fletch tite material itself as a sort of wedge to get the quiver to fit more tightly.