Well I called Bowtech and found the answer, so here it is. The Sims cable slide will pull the cables over a little further causing the idle wheel to slightly cant. If you tune your bow with this cant it will tune and if you want to fix the cant you will have to put twist in the cable at the split (more than likely on the right side). If you choose to do this you will have to retune the bow for center shot. Now back to the cables being pulled too for over. The only thing that this will do is that it will cause the cables to have more pressure in contact with the cable slide. This contact will make wear on the cables faster than a slide that doesn't pull as hard on the cables. Shouldn't effect accuracy, but I just ordered a Hicks today, and will try that out. My only concern is that I am shooting Blazer vanes that have a higher profile. I hope they don't hit. Good luck and shoot straight.