Hello everyone! I was very happy to find this forum! I have been spending alot of time tonight reading posts, and thought I would ask a question, I hope it dosn't seem too dumb! I recently purchased a used model 15 Smith and Wesson Revolver. This gun was in terrible shape when I purchased it, but I figured that if I cleaned it, it would look alot better. Well, after spending the better part of the evening last night it is alot better, however the inside of the barrel is a little bit pitted. It almost looks like someone has shot alot of Plus P ammo through it, and this ammo has caused small burn spots on the inside of the barrel. It could be from rust, and these small pits are due to that alone, but nevertheless, they are there. Here is my question: without looking at it, are there any guidelines that I can go by to tell me wether the weapon is safe to fire with these very small pits in the barrel? And if not, is there a way to have the barrel re-rifled? (if that is indeed a word) Or should the barrel be replaced? And what might something like that cost? I know this is alot to ask, but any help would be greatly appreciated.PS This is a .38 caliber. and otherwise it is in pretty good condition. I have been considering sending it back to S&W for a factory restoration if it didn't cost too much. Anyways thanks again for any help!