Thanks again for the module! I went to screw it in last night and realized that I had torqued the other module so hard that I couldn't get the allen screw out of the bow. I ended up using vice grips on a harsh setting to remove it. Then I had to cut off the buggered end of threads from the screw with a Dremel tool. Thank god it didn't hurt the bow. I gave all the threads a thorough coating of silicone and lightly reassembled them.

Unfortunately, it didn't allow two modules to be attached on the back side like I had hoped. It's about 1/4" too long and hits the inside cable. I did end up placing it as the first one on the front side of the bow followed by a small module and the stabe enhancer. I kept the two smaller modules on the back. This seems to help a little, but only a good shooting session will tell for sure.

I appreciate your help with this.

Have a good one,

Fritz