HuntingNet.com Forums - View Single Post - Eastons ST AXIS shaft
Thread: Eastons ST AXIS shaft
View Single Post
Old 12-17-2003 | 06:33 PM
  #16  
JeffB's Avatar
JeffB
Nontypical Buck
 
Joined: Feb 2003
Posts: 3,058
Likes: 0
From: CT, USA
Default RE: Eastons ST AXIS shaft
ORIGINAL: Len in Maryland

Jeff:

There is a tool for adjusting the insert depth. With a little ingenuity, you can alter the depth of the insert to give you the requirement you need. Be careful, however, because you could mess them up easily.

I don't care for the nocking system. I'm working on a way to change that to an ACC component. Right now there is not one standard size that will fit. Break out the lathe!
Thanx for the tip Len. I knew it came with the tool, but I got the impression you really shouldn't vary the depth too much (if at all) from what the Easton rep told my dealer/friend.

Hmm..have you tried some of the Redline bushings? Or something like a 3-18 or smaller A/C bushing?

How about X-10/ACE pins or similar?
JeffB is offline  
Reply
0