View Single Post
Old 10-13-2010, 03:01 PM
  #11  
bigbulls
Boone & Crockett
 
bigbulls's Avatar
 
Join Date: Feb 2003
Posts: 10,679
Default

Measure from the top axle to nocking point and from the bottom axle to the nocking point. It is not in the center of the string. If you put your loop or nocking point in the dead center of the string (which is where this tool sounds like it would put it) it is going to be at least an inch too low.

Last edited by bigbulls; 10-13-2010 at 03:05 PM.
bigbulls is offline