TeeJay ,

This is from the on-line manual from Diamonds website:

When adjusting the bow’s draw weight
on The Edge and Cutter bows, always
keep the bow at even tiller. Tiller is the
distance between the string and the
point where the back of the limb joins
the riser. The tiller at both the top and
bottom should be equal.If the top or bottom
tiller is off by as little as 1/8’’, the
bow’s performance will be affected.

When adjusting the bow’s draw weight,
do not turn the limb bolts out more than
2-1/2 full turns. Each full revolution of
the limb bolt equals about 2-5 lbs.
depending on bow model.
u WARNING: DO NOT TURN THE LIMB
BOLTS OUT MORE THAN THE RECOMMENDED
AMOUNT. Doing so could
cause the limbs to break out of their
pockets and result in bodily injury.

Don't know if that helps or not ?