ORIGINAL: rjhans53
got to your local hardware store, buy a 3/8 x 16 tap and a bit for it, drill out the primer pocket and back end of the case, tap it, us spacers to hold the 3/8 bolt off the die, thread the bolt in the case with a nut and washer on it with the spacer between the die and washer/nut, tighten up the nut, presto a home made stuck case remover, works good. Hope it helps
Ron
You just described what the stuck case remover basically is...except it's all packaged up in one neat little RCBS box and no spacers and nuts to mess with.