ORIGINAL: Mr. Longbeard
After I trim My brass. I debur the outside of the case than use that tool to put the bevel cut on the inside so the bullet will seat in the brass smothly... What I was wondering... Do you put the bevel cut in the brass every time you load it... Or is once good as long as you dont trim your brass???
You don't have too. But I find I minimize runout when I chamfer the inside a little every load. If you find your scraping copper off of the bullet when seating cause you die is squeezing the neck a little much, then chamfer, if not don't. Sometimes I do, and some cartrdiges I don't.