I AM NOT MAKING THE CONNECTION HERE WITH THE LOW NOCKING POINT & A HIGH PEEP. UNLESS YOU ANCHOR WELL BELOW YOURJAW??? I ASSUME EVERY ONE ANCHORSCLOSE TO THEIR FACE / JAW LINE. ANY WAY CHECK THIS OUT:
CHECK THE HEIGHT FROM WHERE YOUR ARROW RESTS ON THE REST, HOW HIGH IS IT ABOVE THEBOTTOM OF THE RISER ON YOUR BOW? ON MY BOW I HAPPENED TO NOTICE THAT MY SIGHT WAS SET VERY HIGH ON THE MOUNT AFTER IT WAS SIGHTED IN. I DID'NT LIKE IT THIS WAY, SO UPON CHECKING OUT MY REST HEIGHT WHICH WAS SET IN THE MIDDLE OR ZERO OF THE VERTICLE ADJUSTMENT, WHICH I ASSUME IS WHAT MOST SHOPS USE FOR THE INITIAL SETUP AND THEN THEY SET YOUR NOCKING POINT TO THAT (1/4" MORE OR LESS ABOVE THE REST). MY ARROW WAS ABOUT 1 1/2" ABOVE THE BOTTOM OF THE RISER WHEN IN THE REST. SO I LOWERED MY REST ABOUT 3/4" OF AN INCH , RESET MY NOCKING POINT (LOWERED 3/4") AND THIS IN TURN REQUIRED MY SIGHT TO BE LOWERED. BOTTOM LINE YOU HAVE TO BRING YOUR PEEP SIGHT DOWN IN ORDER TO MOVE YOUR SIGHT DOWN. YOUR PEEP SIGHT IS THE SAME AS A REAR SIGHT ON ANY WEAPON IF YOU LOWER IT THIS CAUSES YOUR POINT OF IMPACT TO DROP AND WITH A BOWTHAT MEANS CHASING THE ARROW WITH THE SIGHT ANDHENCE IT HAS TO BE LOWERED TO RAISE WHERE YOUR ARROW HITS.