Homemade plow pics please

[cdi3d]

I have 4 sections from an old farm disc harrow. I would like to make a plow to pull behind my 4 wheeler or garden tractor - It is currently setup like this and is to large:
(((((( ))))))

(((((( ))))))

Can I use 2 sections like this:
((((((

))))))

Or one section like this?
))))))

or will it roll funny and want to pull to one side or the other?

If anyone has some pictures of their setups I would like to see them
please email to info@cdi3d.com or post here
Thanks
Mike

[farm hunter]

cdi3d

You can split it up - even into one section - but it might pull a bit off centered.

If you think the 4 wheeler can pull it -

(((((((
)))))))

is the better arrangement.

Disks like this pull real hard on loose soil. It can/will ruin a transmission if you over-do it.

[cdi3d]

I am thinking of welding some 2" tube steel to allow for this config )))))) (((((( with a 8 deg turn on each set - Should pull a little easier and I can break it down to transport - Should be able to pull it - Most of the soil I am trying to break is old praire ground never broken -
Thanks for the reply - Anything else comes to mind let me know

Mike

[RonM]

Have the front blades throwing out and the rear blades throwing in,How wide is it now while it is all sections together...

[cdi3d]

about 7'6 wide - to wide to pull with my four wheeler and garden tractor - I was hopin for something smaller so I could transport it - and get to remote spots -

Thanks
Mike