Need help with Old Glory cams

sjb3 · 02-09-2005, 04:49 PM

I got my 30" 70# Old Glory in and the draw length seemed short. So my dealer ordered 30.5" cams and got them in about a week(IMPRESSED with this). Now that I have the new cams on how do I know that they are set up right? These did not come marked from the factory like the ones on the bow. The 30" cams were still ok as far as the marks go, just want to be sure the cams are exactly the same to start out with. The a-a is about 1/16 longer, bh is about the same, the only thing that changed was the tiller. Sight pin at 20 yrds was right on. So should I mark the cams where they are or is there a way I can check the cams to be 100% sure they are the same. sjb3

pdq 5oh · 02-09-2005, 08:28 PM

I responded to your PM.

newman1 · 02-15-2005, 02:09 PM

I would ask Len in Mryland!!!!!!!

ijimmy · 02-15-2005, 02:55 PM

The equilizer cams are not suposed to be critical to slightly diferant cabel lengths like a dual cam bow is . I would find out what length they are supoed to be , may be on the limb tag . and twist them or untwist them to spec . They are probably close if you haven messed with them , and then just shoot the bow . With this bow you recieved a tag that says dont twist the cabels more than two turns or the bow may lockup causeing a dangerous situation , so know for sure what you are doing before you take chances messing with it .