the ruber silencers on your bowtech?

[handishooter]

where abouts do you have your rubber silencer located on your limbs?slid down to your riser or toward your cam and wheel.

[KBacon]

I have them slid down by the riser and Limbsavers out by the cams. This is the way that I've seen most of them..

[extreme1]

I have my vibra-blocks up near the cams on my patriot sc and seems to work fine for me.I called bowtech a while back and they told me thats what they reccomend.

[Timbawolf98]

When I first got my Liberty, they were up near the cams. I moved them down near the limb pockets, but I personally couldnt tell any difference (though I have enough rubber/NAVCOM type material on my bow that I shouldnt have any noise or vibration even without them)

For what it's worth, I doubt that Bowtech and the dealers would put them somewhere thats less effective than another place 5" away....

[Kanga]

I set mine to where I normally put limb savers.

[gibblet]

mine came about 1 inch from the limb pockets and i was told that was correct. i also use limb savers near the split of the limbs.

[PABowhntr]

I have them slid down by the riser and Limbsavers out by the cams. This is the way that I've seen most of them..

This is the configuration that I have my Mighty Mite set for though my Pro 40 just has the Vibrablocks close the cams with no limbsavers at all.

[gibblet]

i've moved them around and honestly haven't found any difference in point of impact or noise.