can anyone tell me if the prongs on my NAP quiktune 2000 dropaway should be in contact with the bottom of the cutaway of my riser in the slack position (not drawn)?
They recomend that the prongs should rest on the edge of the arrow shelf and the rubber arrow holder should be slightly under the prongs. So ,when you install the rubber holder, make it hang off the end just a little bit so the prongs will hit it after you fire your bow. They said this will make your shot a little more quiet.
That's the way my 4000 is set up. I just moved the arrow holder toward the strin enough so that the holder wraps dow about a 1/2 " below the shelf and it is whisper quiet.
__________________
Bowhunter
Mathews Switchback XT, Shaffer Mat-1 Dropaway Rest, Toxonics K9 HD 5 pin, Dead On Range Finder, No-Peep, Fletcher .44 Caliper release, Beman ICS 400 Hunter Arrows, Sonic (7/8" 100' s, Simms Modular Stabilizer, Balcom Bowsling.
quiktune 2000
100' s, Simms Modular Stabilizer, Balcom Bowsling.
