Need some help. Please

[big pot of neck bones]

I am having a problem with my setup. Here is what I have.
Browning Mirage SX 60-70 pound 29inch draw.
Trophy ridge matrix flatliner sight
Shakey Hunter drop away rest

Here is my problem: I have the nock point and the true center set up correctly. I have checked this 2 or 3 times to make sure. The problem that I am having it that I am having to move the sight so low and the pins down as far as I can and I still am shooting low. I have the sight so low, that if I would shoot a broadhead it would hit the sight on the bottom. I am shooting only about 7-10 yards. I don't know what to do next. My draw length is correct as the string comes to the tip of my nose and I am always in the same shooting form. Any ideas.

[Rangeball]

Where are you anchoring your release/string hand?

Is the arrow shaft bi-secting the rest hole in the riser?

[big pot of neck bones]

I shoot a release with my thumb anchored behind my jawbone. I don't quit understand you other question.

[trestand]

Just a thought,Do you have to"put your head down",even a little bit,to sight thur your peep?Cause if you do,you could raise your peep up so your looking straight thur your sight.Raising the peep will bring everything up,sight,pins,and your head!...Bob

[big pot of neck bones]

Nevermind, I understand your second question now. And I did have the rest too low. Thanks for the tip.

[big pot of neck bones]

I will check my form again and make sure my head is straight. Thanks again for the headsup. (LOL)