? on a Bitzenburger

[polack]

I am using the straight clamp setup to fletch my arrows, I would like to know what I have to do to fletch right helecal? Could I still use the same jig or do I have to order the jig with the R.H. clamp? Also, how about the nock receiver, do I need a different one?

[keith meador]

you may have answered your own question. use the bitz, but move the lower adjuster to the left, and the upper to the right. this will apply an offset. it is best with vanes. feathers are better suited to a true helical, which does require a different clamp. it doesnt take a lot of offset to get good results, so dont go overboard. good luck to you. also, your nock reciever is fine. if for some reason you are not using some type of bushing or push in nock that is. if you are still using the glue on/ twist on nocks, you can get the other reciever to put your cock vane down/up.

Edited by - keith meador on 02/22/2002 15:50:02

[3D4PSE]

Yes, you can get just the clamp and put helical vanes on your shaft but I do like offset except for big aluminums and traditional arrows.

[polack]

Will I still be able to use the same jig with the right helical clamp?
Polack