Where does Mathews measure their drawlength from?

thenuge15 · 05-24-2004, 07:34 PM

I was wondering where Mathews measures their drawlength from. Is it from string to front of riser? Thanks-Sam

Bowshopper · 05-25-2004, 07:28 AM

More than likely from the deepest part of the nock (touching the string) to the most forward point of the grip, plus 1 3/4".

oaktree#1 · 05-25-2004, 10:24 AM

From the string to the front of the riser in a line through the hole for the rest.

JeffB · 05-25-2004, 06:33 PM

Quote:

ORIGINAL: oaktree#1

From the string to the front of the riser in a line through the hole for the rest.

Oaktree is correct...to the "front" of the riser. That is why all Mathews run about 1/2" to 5/8" long at AMO/ATA spec.