PSE Stinger X help
#1
Spike
Thread Starter
Join Date: Aug 2015
Posts: 1
PSE Stinger X help
This is my situation,
the PSE Stinger X brand new from the factory bought a few weeks ago...
The axle to axle is 3/8 to long...should be 32 1/2 and its 32 7/8.
It's a 70 pound bow but only maxs out to 67.
The draw length feels to short set at 29 inches.
My son is a 29 inch draw and we have to set it a 29 1/2 so it feels comfortable.
The measurements are taken with the limb bolts tightened all the way.
Question is do we leave it like this or do we set it to where it should be?
Reading up on cable/string adjustment seems like if you do one thing it effects a lot of other things.
So right now the timing mark on the one only lower cam is set perfect with the cable.
If I was to twist the yoke cable to get the brace height set and poundage to 70, wouldn't the cam timing be off the mark?
What should I do here?
leave it or adjust it and what do you recommend to do?
Thanks
the PSE Stinger X brand new from the factory bought a few weeks ago...
The axle to axle is 3/8 to long...should be 32 1/2 and its 32 7/8.
It's a 70 pound bow but only maxs out to 67.
The draw length feels to short set at 29 inches.
My son is a 29 inch draw and we have to set it a 29 1/2 so it feels comfortable.
The measurements are taken with the limb bolts tightened all the way.
Question is do we leave it like this or do we set it to where it should be?
Reading up on cable/string adjustment seems like if you do one thing it effects a lot of other things.
So right now the timing mark on the one only lower cam is set perfect with the cable.
If I was to twist the yoke cable to get the brace height set and poundage to 70, wouldn't the cam timing be off the mark?
What should I do here?
leave it or adjust it and what do you recommend to do?
Thanks