? on Limb Savers for Split Limbs on a HCA Four Runner

Browning_1 · 09-25-2003, 02:27 PM

I just picked up some limb savers for my bow which has split limbs. Installed from the factory there are these round limb clamps on each limb. I was wondering if these clamps can be replaced with the limb savers? Has anyone ever done or heard of anything similar being done? The archery shop I bought them at wasn' t sure but he said if they were installed from the factory then you probably should leave them on. Anyone know anything different?

Thanks!

oniedaeagle · 09-25-2003, 02:29 PM

i would mount the limb saver just below that

PA Hardwoods · 09-26-2003, 05:03 AM

leave the clamps on and put the limbsavers on just below them like odiedaeagle said. If the factory has it on there in most cases it is there for a very good reason.

UpNorth · 09-26-2003, 07:54 AM

I used to have a HC Four Runner, I think it was a 2000 model, not carbon. I asked the same question of the dealer I bought it from and with High Country. I took off theirs and put on the limb savers and never had a problem. I guess the safest thing would be to leave the old ones on but I personally took mine off. Try and give High Country a call and see what they say.

Good Luck

Browning_1 · 09-26-2003, 08:33 AM

I put on the limbsavers last night and MAN did it make a huge difference. I left on the factory clamps and put the limbsavers just below them. Thanks for the advice. I also sent in a email to HCA about it but have not received a response as of yet.

tnichols · 09-26-2003, 12:28 PM

I have HCA also, I agree with the other guys put it below the factory' s. The factory one has a pin thru it and it also goes thru the limbs. Pulling that pin out could weaken the limbs.