Peep sight location
#1
Thread Starter
Join Date: Feb 2003
Location: Brownsburg Indiana
Posts: 48
Peep sight location
I have always used a high anchor point. I would like to change to a nose tip/ corner of mouth anchor point. I am using a wrist strap release. Is 6" from nock too high? I am wondering about it lining up with my sight. Will this make my pins spread apart? Thanks.
X-Ring
X-Ring
#3
Fork Horn
Join Date: Feb 2003
Location: Ohio
Posts: 134
RE: Peep sight location
6" doesn't sound to bad.On my target bow my peep height is 6 1/8" from bottom of nocking point.At full draw it is 4 1/4" from center of peep to center of arrow shaft.
Don't worry about the pin gap! As long as your peep is in a comfortable position where you don't have to raise or lower your head to see through it you'll be fine.
I set my peep height for 40 yds.
To set it:Pick the distance most of your shots will be,whether it's 20,30,40 yds.Go to that distance and draw your bow and come to anchor with your eyes closed and your head level........open your eyes and you should be looking through the peep.
Don't worry about the pin gap! As long as your peep is in a comfortable position where you don't have to raise or lower your head to see through it you'll be fine.
I set my peep height for 40 yds.
To set it:Pick the distance most of your shots will be,whether it's 20,30,40 yds.Go to that distance and draw your bow and come to anchor with your eyes closed and your head level........open your eyes and you should be looking through the peep.
Thread
Thread Starter
Forum
Replies
Last Post
CharlieNY
Archery Gear
2
10-17-2006 01:16 PM