Muzzyzeroeffect problem?

DocBars · 03-22-2009, 03:57 PM

Hello Bowhunters
I'am new here and hope that someone can help me with a little problem.
I installed a new muzzzero effect(600pc),everything went smooth.bare shaft tuned good with just a slight right tear(right hand shooter).The big problem came when I shoot my flectched arrows, I'am getting vane contact. I turned cock vane down, I've raised rest up just a little and still getting contact.
I shoot a Parker Buckhunter,35.5 axle to axle,7.25 brace height.
29inch draw @70 pounds
Any suggestions would be appreciated
thanks cd

03-22-2009, 05:45 PM

Well, a few things. Are you sure you have enough cable slide travel to clear? If not you can cross your cables above instead of below. Second, you can time the MZE to fall faster. Put the bow on a drawing table, hook from the ceiling, etc, and you can screw in the arm in and out to adjust for fall time.

DocBars · 03-23-2009, 03:03 PM

bigcountry:
Thanks for the reply,I try your suggestions.
Thanks cd

03-23-2009, 03:07 PM

Quote:

ORIGINAL: DocBars

bigcountry:
Thanks for the reply,I try your suggestions.
Thanks cd

No problem. I have had the MZE on 3 bows. Wished they worked on the newer bows, but bows like my guardian and commander do not have enough cable slide travel.

I like to time mine so it stays up 2-4" max. from full draw.