OnTarget2 users question

[fillae]

I have OnTarget2 and have used it in the past to help select my shaft spine. I have noticed that the although close, it is not perfect. I certainly don't expect it to be perfect, so I have no issues with that. The question I have concerns the "shaft length" property. Does the shaft length they are referring to include the nock, or just the shaft itself?

[TFOX]

If you lay your cursor on the shaft length,it says to use shaft material only,meaning no nock added.

[fillae]

Thanks! You'd think they would put that in the Help file. At least that's where I went to look.

[brucelanthier]

ORIGINAL: fillae

Thanks! You'd think they would put that in the Help file. At least that's where I went to look.

From the OT2 helpfile:





Shaft Length
length of just the arrow shaft (shaft material only)

[fillae]

ORIGINAL: brucelanthier

From the OT2 helpfile:





Shaft Length
length of just the arrow shaft (shaft material only)

I found it. It was under the help for the Equipment tab. This is all that shows up in the help for the Spine Match tab:

Shaft Frame
Shaft Length - shaft length of the arrow


And then the equipment tab:

Shaft Frame
Shaft Model - model or type of arrow (ACC, ACE, etc.)
Shaft Size - size descriptor of the arrow (3-18, 2216, etc)
Shaft Per Inch - shaft weight per inch
Shaft Length - length of just the arrow shaft (shaft material only)
Shaft Diameter - outside diameter of shaft material
Shaft Spine - the manufacturer's static spine rating for the shaft

I guess I should have spent a little more time reading!