Correcting my brace height

[jbowersox]

All right, here is my problem...My axle to axle length is good, but my brace height is short. I have a Diamond Marquis that should have a 7" brace height. Mine currently measures a little over 6.75". I have two questions...
1) How would this effect my bow?
2) How do you correctly fix it?

[TFOX]

Chances are it is right where it should be.Those brace heights and a-a measurements are for STANDARD configurations and to the best of my knowledge,they are taken on a 70# bow bottomed out at 70# and a 30" draw bow set at 30".

You are probably right where you should be and a quick call to the manufactuer could probably get the exact measurement you should be at your configuration.

[jbowersox]

TFOX, how would the shorter brace height effect my bow? I the a2a is on the poundage should be correct...? Right? But if the brace height is off what does it effect...? Draw length? How would both of these effect speed? I don't know, I'm just trying to get an idea as to what might be going on. The reason I ask is I feel like I'm not getting the speed I should out of my Marquis. I'm shooting a 351 gr arrow at 281 fps. (Draw 28" with a g5 meta peep, and a string loop) I just feel like I should be shooting a little faster than that. Maybe not.

[TFOX]

If the brace is off then chances are that so will the draw length,poundage and speed.

You are definately below the speed you should be if all your numbers are correct.