CARBON EXPRESS CX350 EDGE ARROWS

[ar34muzzyman]

I HAVE A 27.5 INCH ARROW LENGHT,BOWS AT 56PDS,100 GRAIN TIPS WITH INSERTS,AND BLAZER VAINS,I SHOOT OUT OF MY AR34.WILL THE CARBON EXPRESS CX350 EDGE WORK FOR ME??IF SO DO I NEED TO CHANGE TIP SIZE?? THANKS FOR ANY HELP!!!!!!!!!!!!

350's no way at 27.5". I would go much lower spine. I shoot a 29" 350 out of my 70lbs single came with 29.5" draw. At 27.5", your much stiffer.

[davepjr71]

big is right on the money with that arrow being way too stiff. Eve na 125 gr tip wouldn't be enough to get the spine down to a little overspined.

You should probably be using the 250 series with your draw weight and arrow length.

[ar34muzzyman]

Thanks guys!-I was able too buy 12 of the cx350-crested-and new blazers for 30.00 from a guy a work.So being to stiff will do what and will it hurt my bow any?If i go too 125 grain tips?-just hoping i could figure out something

ORIGINAL: ar34muzzyman

Thanks guys!-I was able too buy 12 of the cx350-crested-and new blazers for 30.00 from a guy a work.So being to stiff will do what and will it hurt my bow any?If i go too 125 grain tips?-just hoping i could figure out something

Lots of things you can do. You can add brass ends to it. I dont' think they make brass inserts for the edges as you have to use the extended inserts for some reason.

All its going to do is give you bad arrow flight. Or a fishtailing action.

All you can do is paper tune and see how it works. If you see alot of fishtailing, Keep adding brass wieght to the front until you don't.