racer965

hey guys just got my bow was wondering if any of u know how many turns out the limbs go?? its a reflex excursion. Also how to change the draw length.

racer965

hey guys got the how many turns out now i just need to know how to adjust the draw length. Do i need a bow press or just looosen those screws on the cam and adjust it back and forth.

mobow

You need to move the module...remove the small allen screw that secures it and move both ends to the same hole....they are labeled....A, B, C, D I believe....I also believe they are adjustable in 1 inch increment, not 1/2 like the Hoyt's are.

lrhuntr

Yeah just got my highlander and had to change the draw lenght as well. Just loosen those screws and move it to your draw length should say 27-30 or what ever yours is. If you have your manual for the bow it will tell u in there too. Good luck.

ol eagle eyes

On my Buckskin the limb ends went over top of the adjustment screws on the cams. Was a pain but I had to rotate the cams slightly to get to the screws. Not sure if you'll have this problem.

ButchA

That is right... When I got my Reflex Highlander, it was set at "30". The bow shop re-measured me and we decided to drop me down to "29". It was easy for the bowshop to do. Undo the allen bolt, rotate the module to the appropriate setting, and tighten it back up.

Butch A.