hey guys got the how many turns out now i just need to know how to adjust the draw length. Do i need a bow press or just looosen those screws on the cam and adjust it back and forth.
You need to move the module...remove the small allen screw that secures it and move both ends to the same hole....they are labeled....A, B, C, D I believe....I also believe they are adjustable in 1 inch increment, not 1/2 like the Hoyt's are.
__________________
1995 Ford Ranger XL
Douglas Radial Tires
Super Blue headlights
Fiberglass front bumper
2400 pounds
Yeah just got my highlander and had to change the draw lenght as well. Just loosen those screws and move it to your draw length should say 27-30 or what ever yours is. If you have your manual for the bow it will tell u in there too. Good luck.
__________________ Good people sleep peaceably in their beds at night only because rough men stand ready to do violence on their behalf.
On my Buckskin the limb ends went over top of the adjustment screws on the cams. Was a pain but I had to rotate the cams slightly to get to the screws. Not sure if you'll have this problem.
Yeah just got my highlander and had to change the draw lenght as well. Just loosen those screws and move it to your draw length should say 27-30 or what ever yours is. If you have your manual for the bow it will tell u in there too. Good luck.
That is right... When I got my Reflex Highlander, it was set at "30". The bow shop re-measured me and we decided to drop me down to "29". It was easy for the bowshop to do. Undo the allen bolt, rotate the module to the appropriate setting, and tighten it back up.
REflex bow
