need help on bowtech justice!
ok when i noticed my stepson shooting the other day i noticed the arrow was at a significant down ward angle at full draw. we put a level on the sight and a level on the arrow at full draw an they were not even close. i know you are going to have a slight downward angle at full draw but this was not even close to being in the bubble. any ideas on what would cause this.the bow is set to spec a/a and brace height. if they are set close to being level it gets a real high tear high. to get a close bullet hole the loop has to be way over a 1/8 high from center. the arrows are spined correctly with no right or left tear at all. any ideas. thanks
|
