logo
 

Go Back   HuntingNet.com Forums > Archery Forums > Technical

Technical Find or ask for all the information on setting up, tuning, and shooting your bow. If it's the technical side of archery, you'll find it here.

Reply
 
Thread Tools
Old 09-25-2006, 08:23 PM   #1
 
Join Date: Jul 2006
Location: Southern Illinois
Posts: 55
Default Need some help with tuning...

I had a problem with my Wac-em's diving on me. From everything I've read I should move my nocking point down. I tried doing that a little at a time and it moved my bh's up but also my fp's. They never seemed to come together. I moved it enough that I could tell just by looking at it that I was way out of whack. I also noticed a difference by using Lumenoks that I never noticed with my fp's. With the lumenoks the bh's seemed to fly more erratic but flying to the left alot of times. I'm one of those guys that just has a hard time shooting bh's. Some of my shots looked like the bh arrow was kicking horribly but the fp would fly fine so I know some of it is me. Could somebody please help me out with this. Any suggestions please!!!![:@]


__________________
hoyt x-tec, 29"/62lbs
trophy taker
gold tips, 7595(wrapped and blazed)
100 gr. tricks & wac em's
dnutt is offline   Reply With Quote
Old 09-26-2006, 04:30 AM   #2
 
Join Date: Feb 2003
Location:
Posts: 2,413
Default RE: Need some help with tuning...

If it was me, I'd start from the beginning. Getting proper arrow tune is the most important aspect of archery. Get a bare shaft and test for spine. If your spine is way off, you can tune until the cows come home, and you'll never get a good flying broadhead. After you have the spine adjusted - by changing tip weight, shortening the arrow or changing draw weight, you can also check nock height with the bareshaft test.

After you're done with the bareshaft testing, then walk-back tune the bow. Go back to at least 60 yards to get windage set accurately.

General keys to good broadhead flight are:

High FOC %. I recommend an FOC of at least 12%, especially for anyone who isn't very good at tuning and arrow. Higher is even better.

The fletching should be feathers attached with a helical twist. It is very important to get adequate drag on the rear of the arrow and to have the arrow spinning. Feathers are very good at this, plus they reduce the weight at the rear, which is also a good thing.

Arrows that are straight with broadheads that are attached perfectly straight. This is fairly easy to test at most archery shops.

Spine tuning: Very beneficial if you have the equipment to do it.

Don't worry for one second about what any of this does to arrow speed. It has no importance. All you should be concerned with, is getting your broadheads flying properly. If you do all this properly, your broadheads will hit very close to your field tips, even in breezy conditions.

Straightarrow is offline   Reply With Quote
Old 09-26-2006, 06:26 AM   #3
Nontypical Buck
 
ijimmy's Avatar
 
Join Date: Feb 2003
Location: WEST PALM FLORIDA
Posts: 2,864
Default RE: Need some help with tuning...

Make sure your arrows are spined correctly , use enough fletching to stear your fixed blades , lose they luminocks [probably the bigest problem] they are junk
__________________
Wear a full harness and tie yourself to your tree !
Take a kid hunting or fishing .
Nocks , the most overlooked component .
ijimmy is offline   Reply With Quote
Old 09-26-2006, 02:19 PM   #4
 
Join Date: Jul 2006
Location: Southern Illinois
Posts: 55
Default RE: Need some help with tuning...

How exactly do I test for spine? And also why would I notice a difference with the lumenoks now when I never have in the past?? Thanks again.
__________________
hoyt x-tec, 29"/62lbs
trophy taker
gold tips, 7595(wrapped and blazed)
100 gr. tricks & wac em's
dnutt is offline   Reply With Quote
Old 09-26-2006, 03:29 PM   #5
 
Join Date: Feb 2006
Location: Kodiak, AK
Posts: 2,877
Default RE: Need some help with tuning...

If you have gone out of cetershot on your bow the extra weight of the Luminock will accentuate any problems you're having. Get your rig back to center shot and start over. When broadhead tuning the key word is that it is "fine" tuning; make very small adjustments. I generally can't slide a nock set down in small enough increments so I use the fine tuning adjustments on the rest, this is where the NAP 4000 and 3000 series rests really shine.
KodiakArcher is offline   Reply With Quote
Old 09-28-2006, 05:23 AM   #6
 
Join Date: Feb 2003
Location:
Posts: 2,413
Default RE: Need some help with tuning...

Quote:
ORIGINAL: dnutt

How exactly do I test for spine? And also why would I notice a difference with the lumenoks now when I never have in the past?? Thanks again.
Are you asking about a spine tester to actually measure spine, or do you want to know how to bareshaft tune for spine?
Straightarrow is offline   Reply With Quote
 
 
Reply


Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off

Similar Threads
Thread Thread Starter Forum Replies Last Post
MOVED: Walkback tuning and bareshaft tuning redneck buck hunter Bowhunting 0 12-16-2008 10:16 PM
Somebody Explain Walk Back Tuning and Group tuning to me, killadoe Technical 1 05-21-2008 12:16 PM
MOVED: Somebody Explain Walk Back Tuning and Group tuning to me, killadoe Bowhunting 0 05-21-2008 12:16 PM
Paper tuning and bare shaft tuning PSEsilverhawk55 Bowhunting 2 08-09-2005 02:36 PM
FINE TUNING BOW WHEN PAPER TUNING gross144 Technical 6 06-02-2004 05:10 PM

 

All times are GMT -8. The time now is 02:53 PM.