Cam marks do not lign up

[ricoace]

Hi everybody
I have a mathews ultra 2 . Just had the strings changed yesterday, when I got the bow home I noticed that the cam marks(marks to show me string stretch) were off by a almost a half a inch to the strethced side.meaning that even with a fully "broke" in string, my cam marks would not be off than more than a quarter inch at the most.

To put it simply, my cam marks are off more than a half an inch than they were two years ago when i had the strings changed...before I take this bow back, can any of you tell me what might be going on? I checked the poundage and it is correct...I also checked cable positionand it is on the "no 1 slot on the cam

I havent shot the bow yet...

[wis_bow_huntr]

Sounds like Cams are out of time. Your proshop did a half ass job if you ask me. Take it back.

[ricoace]

Thats what i think too wis...was supposed to go hog hunting tomorow...

[Monie]

Take the bow back and tell your tech about your timing marks (he should have put it in time to begin with), and have him readjust the string, (add/subtract twists).

[ricoace]

Thats what I did, and thats what he did, gave me a few more twists...I dont remember who or where I got the information to always mark my cams, but it sure has saved me a couple of times...MARK YOUR CAMS

Thank you Monie and thank you all