TRIBUTE AND WHISKER BISQUIT????

[weatherby460]

cant get it to paper tune

bowtech tribute
64lbs
whisker bisquit
maxima 250 arrows 330 grains total weight


i have the arrow pretty much parallel to the riser holes going thru the middle
(maybe 1/8" nok high)

I am getting a tear that is point low and to the left......or tail high and to the right.

if i adjust the rest in towards the riser, I get a worse tear with the tail to the right......[/align][/align]
i moved the rest too 13/16"...and still rips.....going in closer only seems to make it worse......then i tried 57 lbs to 68 lbs and it still rips....funny thing is it never changes the tear when adjusting the weight, that tells me the arrows are most likely fine.....again i am getting a tail high and tail right.



any other ideas??????????[/align]

whats going on.[/align]

[weatherby460]

here is a picture

[DaveC]

Yikes!
Thhis may sound silly, but if you are using the "deluxe" WB model check for fletching contact on the holding bar.

I take it the tear on the right is bare shaft?

Not sure about the spine kick, but you could try leveling the nocking point if you are using a loop. (arrow dead center of burger holes & perindicualr to string)
Let us know if you get anywhere with this.