Antler broke off?
#11
Good Ole Boy i have only have done it on the sawed off skull plates. I looked over some skulls and it could still be done, with them, it would be a bit more difficult though. You just have to have things (blocks,books,wire) set up when you do the final epoxy, so it's in the final position to dry/harden.
#17
Typical Buck
Thread Starter
Join Date: Dec 2013
Location: Pa.
Posts: 502
I was doin some repair work today and was usin FS110 Industrial Contractor Adhesive and got the idea to try it on the antler since I already had the tube opened.It is slow setting and hopefully it will hold.If not,back to the drawin board.I,m just concerned that the adhesive will stay tacky and not get rock hard.If it gets hard it should be good.
#18
Typical Buck
Thread Starter
Join Date: Dec 2013
Location: Pa.
Posts: 502
So far so good.It appears to be holdin but don,t want to test it per se.My friend ought to be happy.The adhesive bonds good but don,t get rock hard it appears.If not handles excessively I,m hopin it holds.Hopefully when mounted gravity won,t take it,s toll cause the broken antler is long and lankey.