Powder convertion

[apple12]

I'm looking a table that I can use to change 1 powder to another 1.
I have limited funds and only a few powders to use. I found this load
the web for my 243 wssm IMR 4895 46.0 grains max I would like to
use IMR 4064. I look last night for a hour found nothig. Any help plz.

ORIGINAL: apple12

I'm looking a table that I can use to change 1 powder to another 1.
I have limited funds and only a few powders to use. I found this load
the web for my 243 wssm IMR 4895 46.0 grains max I would like to
use IMR 4064. I look last night for a hour found nothig. Any help plz.

You can keep looking cause a load is for a particular rifle. That someone worked up in a particular rifle. No one can give you an exact load and expect the same results. I am not being smart, but this should be know by anyone reloading ammo.

[apple12]

bigcountry I was not looking for the same load and results, I just wanted to be safe I was looking for a good starting point. I'm still looking.

thx

www.hodgdon.com has IMR4064 loads for 58-100gr bullets for 243WSSM.

Hodgdon now owns IMR.

58 GR. HDY V-MAX
58
IMR 4064
.243"
2.220"
42.5
3698
49,300 PSI
45.5
3966
60,400 PSI

70 GR. NOS BT
70
IMR 4064
.243"
2.280"
40.0
3420
49,100 PSI
43.5
3672
61,900 PSI
80 GR. SIE BTSP
80
IMR 4064
.243"
2.220"
39.0
3250
51,700 PSI
42.2
3458
62,400 PSI

90 GR. SFT SCIR
90
IMR 4064
.243"
2.300"
36.0
2995
54,900 PSI
38.3
3138
61,600 PSI

100 GR. SPR BTSP
100
IMR 4064
.243"
2.300"
35.0
2847
53,000 PSI
38.0
3029
62,300 PSI
PSI

[apple12]

thx for help

[eldeguello]

ORIGINAL: apple12

I'm looking a table that I can use to change 1 powder to another 1.
I have limited funds and only a few powders to use. I found this load
the web for my 243 wssm IMR 4895 46.0 grains max I would like to
use IMR 4064. I look last night for a hour found nothig. Any help plz.

I don't know what chart you're looking at, but if it is a powder relative burning rate chart, it really doesn't let you convert from one powder to the another. One reason is that two powders' relative burning rates can SWAP PLACES depending on what round they are being used in, and the pressure levels to which they are loaded.

So to be safe, please refer to a loading table to determinre the actual starting loads for any powder & bullet combination.

For a load using IMR 4064 in that cartridge, I would recommend that you check the IMR Powder Co. website. It is likely that that new cartridge hasn't made it into everybody's loading manual yet.

[steve4102]

Here you go. A web site devoted to the WSSMs.
http://wssmzone.com/main/default.aspx?c=reloading&c2=reload243&c3=r eload243data&n=reloading&d=1